I wanted to know if the DDM (dynamic designer motion) add-on that I purchased in 2016 will work with the latest version of SolidEdge ?

DDM Version is 10.5

Build date Sep 18 2015 1970

I tried to send an e-mail but I get the error 550 high probability of spam.

Please forgive me if this the wrong place to post.

]]>
Healme wrote:1. Connect to the coordinate system to be observed a belt constraint |

Choose a gear transmission (Spur Gear) instead of a belt transmission, because strange effects (slip?) can occur with belts.

]]>
I have found a simple workaround.

1. Connect to the coordinate system to be observed a belt constraint with a transmission ratio of 0.0001 or even smaller, depends on the revolutions you want to count.

2. Divide the angle on the large belt wheel by the transmission ratio and again by 360 degrees.

3. If necessary, subtract the starting angle of the coordinate system so that the counter starts at 0.

4. If you still want to delete the units, you can extend the formula with "/ deg".

]]>
What is the easiest way to count the revolutions of a spinning coordinate system?

Edited by Healme - Jul 10 2020 at 5:12am]]>